We recommend washing your wig or hairpiece every 6-8 wears

Cleanse & Condition

  • Before washing your HD wig or hairpiece, gently remove any tangles with your Jon Renau wide tooth comb ONLY
  • Hold wig or hairpiece under cool running water.
  • Gently lather the hair with a capful of Shampoo while making sure that the hair is traveling in the same direction. DO NOT rub hair as this may cause tangling
  • Rinse thoroughly with cool water until water runs clear.
  • Wrap wig or hairpiece in a towel and gently pat dry
  • Gently detangle hair using your Jon Renau wide tooth comb
  • Spray with Leave-In Conditioning Spray (3-5 pumps) keeping away from base of wig or hairpiece

Dry & Style

  • Air drying your wig will give the best results. You can gently blow dry (low-medium heat) using ONLY your Jon Renau wide tooth comb
  • Apply HD Smooth Detangling Spray, (3-5 pumps) focusing on the bottom half of wig or hairpiece. Gently comb through again with your Jon Renau wide tooth comb
  • We recommend that ONLY the Jon Renau wide tooth comb is used on your HD wig or hairpiece. Other tools will cause frizzing/tangling
  • HD Fiber can withstand heat tools up to 350° F, however, Jon Renau recommends working at 270°-280° F
  • It is recommended to use professional grade heat styling tools with digital temperature settings to control heat

Curl:

  • Heat your curling iron to 270°-280°F
  • Using your Jon Renau wide tooth comb, gently comb hair free of tangles
  • Starting at the nape, take ½ inch-1.5 inch sections of hair (Smaller sections=tighter curls, larger sections=looser curls)
  • Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)
  • Gather hair into curling iron, smooth through to the ends. Roll iron up towards base of wig or hairpiece, staying 1-2 inches away
  • Hold for 10-15 seconds, then turn the tip of iron toward the ground and release curl into palm of hand
  • Holding curl in one hand, gather up towards base and secure curl with a small metal clip (like a pin curl)
  • Allow curl to cool completely (about 5 minutes); remove clip and let curl hang naturally
  • Hair can be combed with your Jon Renau wide tooth comb(or fingers for best results) to blend curls

Flat Iron:

  • Heat your flat iron to 270°-280°F
  • Starting at the nape, take ½ inch-1.5 inch sections
  • Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)
  • Staying at least 1-2 inches away from base, slowly smooth flat iron down through ends
  • Keep hair smooth by following behind the flat iron with your Jon Renau wide tooth comb
  • Allow hair to hang naturally and cool completely

Tips

  • We recommend using HD Smooth Detangling Spray with a Jon Renau wide tooth comb DAILY to detangle your HD wig. This is especially important with the mid-length to long length HD wigs or hairpieces
  • We offer HD Smooth in a convenient 2oz. size for travel
  • Allow your HD wig to air dry naturally instead of blow drying to help maintain the integrity of the fiber
  • Help protect the fiber against heat damage by using Heat Treat Thermal Spray when using heat styling tools