HD | Heat Defiant Care & Tips

We recommend washing your wig every 6-8 wears

 

Cleanse & Condition

  • Before washing your HD wig or hairpiece, gently remove any tangles with your Jon Renau wide tooth comb ONLY

  • Hold wig or hairpiece under cool running water.  

  • Gently lather the hair with a capful of Shampoo while making sure that the hair is traveling in the same direction. DO NOT rub hair as this may cause tangling

  • Rinse thoroughly in cool water until the water runs clear

  • Wrap wig or hairpiece in a towel and gently pat dry 

  • Gently detangle hair using your Jon Renau wide tooth comb

  • Spray with Leave-In Conditioning Spray (3-5 pumps) keeping away from base of wig or hairpiece

     

Curl

  • Heat your curling iron to 270°-280° F

  • Using your Jon Renau wide tooth comb, gently comb hair free of tangles

  • Starting at the nape, take ½ inch-1.5 inch sections of hair (Smaller sections=tighter curls, larger sections=looser curls)

  • Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)

  • Gather hair into curling iron, smooth through to the ends. Roll iron up towards base of wig or hairpiece, staying 1-2 inches away

  • Hold for 10-15 seconds, then turn the tip of iron toward the ground and release curl into palm of hand

  • Holding curl in one hand, gather up towards base and secure curl with a small metal clip (like a pin curl)

  • Allow curl to cool completely (about 5 minutes); remove clip and let curl hang naturally

  • Hair can be combed with your Jon Renau wide tooth comb (or fingers for best results) to blend curls

Dry & Style

  • Air drying your wig will give the best results. You can gently blow dry (low-medium heat) using ONLY your Jon Renau wide tooth comb

  • Apply HD Smooth Detangling Spray, (3-5 pumps) focusing on the bottom half of wig or hairpiece. Gently comb through again with your Jon Renau wide tooth comb

  • We recommend that ONLY the Jon Renau wide tooth comb is used on your HD wig or hairpiece. Other tools will cause frizzing/tangling

  • HD Fiber can withstand heat tools up to 350° F, however, Jon Renau recommends working at 270°-280° F

  • It is recommended to use professional grade heat styling tools with digital temperature settings to control heat

 

 

Flat Iron

  • Heat your flat iron to 270°-280° F

  • Starting at the nape, take ½ inch-1.5 inch sections

  • Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)

  • Staying at least 1-2 inches away from base, slowly smooth flat iron down through ends

  • Keep hair smooth by following behind the flat iron with your Jon Renau wide tooth comb

  • Allow hair to hang naturally and cool completely 

 

Tips

  • We recommend using HD Smooth Detangling Spray with a Jon Renau wide tooth comb DAILY to detangle your HD wig. This is especially important with the mid-length to long length HD wigs or hairpieces

  • We offer HD Smooth in a convenient 2oz. size for travel

  • Allow your HD wig to air dry naturally instead of blow drying to help maintain the integrity of the fiber

  • Help protect the fiber against heat damage by using Heat Treat Thermal Spray when using heat styling tools

There are no products matching the selection.